· Mustang
· MustangII
· Cougar
· Falcon
· Ranchero
· Comet
· Maverick
· Torino
· StreetRods
· Hot Rods
· Manyothers that use same size bearings
· ALL65-73 V8 Mustangs & V8 Mustang II had the small bearing rear ends, whether8" or 9".
· Bracketshave two sets of bolt holes to fit 65-73 or Mustang II.
· BRACKETS
· ATTACHINGBOLTS
· ROTORCENTERING RINGS
· Usethese brackets and bolts, then addyour ownpair of94-2004Cobra rearcalipers and a pair of 11.65" 94-04 Cobrarearrotors and a pair of matching hoses to installreardiscbrakes on your FORD. Complete instructions included.
- 8" (also fits smaller Mustang II 8" rear axle) with 2.836 bearing and 3/8"bearing retainerbolts 3.375x2.00 pattern
- 9" with small 2.836 bearing and 3/8" bearing retainerbolts 3.375x2.00 pattern.
- SEE MY OTHER ITEMS if you need LARGE BEARING size.
- See my other sales or my store for:
- FRONT COBRA DISC BRAKE BRACKETS
- FRONT AND REAR 05-2014 Mustang GT DISC BRAKE BRACKETS
- Buy both sets and get free shipping on second set.
- Precision fit bolts and nuts
- Bracket set includes hub centering ring for the rotor. (in the small bearing kit only)
- Instruction sheet detailing complete installation
- Requires 16" or 17" wheels, 17" preferred. Wheel must clear stock Cobra brake setup as these duplicate the dimensions exactly of a 94-04 Cobra. SOME 15" wheels will clear the COBRA REAR brakes, but fronts require 17".
- Don't want late model Ford factory wheels? This design lets you have the COBRA BRAKES and run many different aftermarket wheels, if they have the correct backspacing and will clear the caliper.
- NO WHEEL SPACER REQUIRED, at all! Of course, the late model 17x8 Mustang wheels will fit as well using a billet aluminum 1" spacer. (The deeper offset of the 94-04 Mustang wheel requires the spacer, NOT the brake setup)
- PURCHASER IS RESPONSIBLE FOR DETERMINING WHEEL FITMENT FOR YOUR VEHICLE!!!!!!!!!!
- The COBRA caliper is mounted in exactly the same position as the Ford Mustang Cobra caliper, avoiding rotating the caliper to a different position and causing possible air entrapment bleeding issues.
- Wheel bearing replacement is required when installing these conversion brackets.
·Rear Calipers from 94-2004 CobraMustang (COBRA are direct fit, GT or V6 require widening of the slot where theyfit over the rotor)
·Rotors from 94-2004 Cobra
·Hoses from 77-80 Versailles or 94-98Cobra
·Shorten rear hard lines
·Bolt or muffler clamp around axle forhose/hard linemount point
·E-brake cables from 94-2004 Mustang orfrom MustangSteve
Related Items:
Schwinn Atom Drum Brake Adjuster Krate Bicycle-Manta Ray / Krate Disc Rear Brake
$16.50
Front Brakes and RotorsKit |Front Brake Pads| Brake Rotors and Pads|SemiMetallic
$84.65
New CROSSPRO DTC Rear Disc Guard For HUSQVARNA 2-CP09201870301
$102.81
